« previous next »
Pages: 1 [2]

Author Topic: Making a Sloped Ceiling  (Read 987 times)

Allan Chesney

  • Administrator
  • Hero Member
  • *****
  • Posts: 2881
    • View Profile
    • www.alchesdesigns.iinet.net.au
Re: Making a Sloped Ceiling
« Reply #15 on: January 13, 2008, 04:29:04 pm »
Wendy,

Have you got Hardware Acceleration turned off?  If not try it with it off.  Settings/Program Settings/Graphics. Are you following the method mentioned in this quote from above?

Quote from: Allan Chesney on December 19, 2007, 02:31:37 am
Just set 3 edges of the ceiling to 90 Degrees and it will slope whether there is a roof or not.


Allan
Logged
Allan Chesney,
Kalamunda, Perth, Western Australia
www.alchesdesigns.iinet.net.au

TurboFloorPlan V16.0.C1.901
Envisioneer CS 7.2.C1.972
TurboCAD V17 Professional

Doug.S

  • Hero Member
  • *****
  • Posts: 1137
    • View Profile
Re: Making a Sloped Ceiling
« Reply #16 on: January 13, 2008, 09:14:10 pm »
I don't know of any patches to date but would expect one soon (I hope).

If not already done so, try the same with hardware acceleration "off" (unchecked) as HA has caused lots of odd issues on various PCs.  For example it is always "on" in my laptop but desktop is on OK for drawing but must be "off" for renders.
Logged
Pages: 1 [2]
« previous next »