Register
 
TurboFloorPlan 2017 is Shipping!!!

Wall Length
Read 1195 times
* December 10, 2012, 06:19:48 PM
When you draw a wall that doesn't connect with anything (e.g. a wind breaker on a porch) there is no easy way to edit the length of the wall other than draw a "small room", edit the length and delete the unwanted walls.  Even though the dimension is shown when the initial wall is drawn you can't end the wall at the shown distance due to wall thickness and the fact that the wall "expects" to take a 90 turn at that point.  It would be good to be able to edit the length by selecting the dimension shown initially, even after the wall is created as this dimension is never shown again.

Thanks,

Logged


* December 10, 2012, 08:41:15 PM
#1
I just snap a dimension to the start of the wall and enter the length of the wall I need in Inspector which makes the dimension the length I need.

Then just drag / snap the other wall end to the dimension snap point.

Delete dimension when done. Although you need it anyhow for construction purposes.

Jack