Register
 
TurboFloorPlan 2017 is Shipping!!!

Open Sided Pavillion - Brick Veneer
Read 240 times
* February 04, 2017, 05:56:47 PM
Hi Forum,

Just looking for tips and tricks.

I want to draw a tile roof open sided outdoor pavillion, but I cannot get the brick walls to render correctly unless I close them to form a room. The thought is to have a full-width lintel above two small piers on either side of the opening. Very similar to a brick garage without any door.

I suspect experienced users will have a way around this?

Regards,
Justin.

Logged


* April 19, 2017, 05:43:27 PM
#1
HI Justin,

Sorry about the delay but have only just noticed your question since the forum has been updated. You probably have it solved by now, but in case you haven't.......

The proper way to get a lintel over the opening is to do a full wall, (so you have a 'room's and hence the outside texture you require), is to use the Openings tool.  This just cuts an opening like a door but with no actual door.

You could of course just do the 3 walls and set the exterior texture to both sides of the wall but that can cause photorealistic rendering issues. No sure which version you have but later versions also have an option to 'Force Exterior Surface' which made the 3 walls into exterior surfaces.

Allan

Logged
Allan Chesney,
Kalamunda, Perth, Western Australia
www.alchesdesigns.iinet.net.au

TurboFloorPlan Home and Landscape Pro V16.0.C1.901
Envisioneer Construction Suite V9.1.2.1234
TurboCAD V17 Professional