Is it possible to move the drawing (or elements in the drawing) on different locations at the same time., or must the drawing on each location be moved individually. I tried to move the first floor plan to another section of the drawing sheet but only the current location would move, I then had to select the ground floor location to move the ground floor plan.
Hi Burgo,
This was answered a few days ago in this post http://forums.turbofloorplan.com/index.php/topic,2204.0.html (http://forums.turbofloorplan.com/index.php/topic,2204.0.html), the key part of the answer being this:
... you first need to go to Settings / Program Setttings / Building Aids and untick the box "Select elements on current location only while in plan view", then go to Edit / Select All (Control+A), then right click and \select Move. If it still will not move turn Collision off (Status bar lower left).
Don't forget to un-tick the "Select elements on current location only while in plan view" box again, or you could find yourself selecting things you did not intend.
Allan
Thanks Allan, again learning the tricks of the trade.