Hi guys,
I've been "away" for a while working on projects. I saw the need to draw up our manual drawing room for some promotional stuff...I didn't go into a lot of detail (no doorknobs, and the sink has no hole in it...) But I like the overall look.
Gaz
Hi Garry,
Looks great! The lighting from the sides gives it excellent depth and 3D appearance.
Do you plan to take it further or does time /work not permit that?
Allan
Hi Garry,
Nice job!
Jack
Nice work. I support Allan on the light comment.
Hi Garry, nice work!
Kajvin
Hi everyone,
Thnaks for taking a look, and for your comments.
Quote from: Allan Chesney on August 31, 2012, 05:55:47 AM
Looks great! The lighting from the sides gives it excellent depth and 3D appearance.
Do you plan to take it further or does time /work not permit that?
Hey Allan...I
shouldn't devote any more time to this, and I
should spend more time on jobs, but I might try and get a bit more time in on this one as it'll be used in promotions for work. I have another project near completion at the moment that's coming along nicely and I might try and post a pic of it soon.
Gaz
Hi Garry,
The reason I asked was because, although as I said before, the lighting is very effective, but at the same time it looks as though the ceiling lights should be on (especially being a drawing office). I wondered if you had had problems with them or had Just not planned to go that far.
Allan
Hi Allan,
After putting in one ceiling light and making sure it was "on", I just copied all the others into place...assuming they'd all be on...do I have to check EACH one, one at a time???
Gaz
Hi Garry,
No - all lights should be on if you copied them. Do you have Daylight ON? If so, try turning it off.
Allan
OH! I forgot to turn daylight off when I'm inside...silly Garry, silly!
Okay...turned the sun off...added some detail to make it look more "lived in"...much better...thanks Allan.
Gaz