Print Page - Stairs

Title: Stairs
Post by: aboardduet on October 06, 2007, 03:01:57 PM

When I try to insert stairs in an automatic floor, I stall when the "hole" I've defined fails to "select", therefore I can't delete it to cut the hole. Any help??

Thanks

Title: See 'Openings'
Post by: Jack Zimmer on October 06, 2007, 03:32:27 PM

Look in Help under 'Openings' / Inserting in Floors / Automatic and Removing from Floors / Automatic

short answer is to go to 3D view , select Room Division floor area / hit Delete.

Z

Title: Re: Stairs
Post by: aboardduet on October 07, 2007, 03:28:54 PM

Thanks Jack. Worked just like it should. A note to the effect might be added to the instructions to make it clear that the moves are made in 3D. The 2D inference is there when it says: "Go into 3D view and make sure that the floor is visible in the view".

Title: Re: Stairs
Post by: Jack Zimmer on October 07, 2007, 03:40:47 PM

Good to hear it worked , good suggestion for instructions.

Z

FloorPlan User Forum

General Category - V.16 and Earlier => V12 - V16 Looking for Help? => Topic started by: aboardduet on October 06, 2007, 03:01:57 PM