i have fitted a bay window into a curved wall, when i view it from the inside there is a piece that is at the top & bottom of the window that is shown on the inside that looks like the floor or ceiling, can i get rid of this.
You are looking at the 'frame' of the window and that cannot be removed. Depending on the appearance you want, you could use a bow window, or place individual windows to fill the curve.
If you do actually want the curve wall to extend outward at the area where you now have the bay, you can break the wall (right click/ break) in two places (the width of the needed 'bay affect'. Then grab the two ends of that broken section of wall , drag them in slightly to 'seperate' from the main curved wall.
Now , select that curved section, right click and 'move'. Slide the wall break 'outwards', use a new wall section to 'close the two ends'.
Then place any casement window of choice to give the bay affect with full floor to ceiling wall heights.
thanks jack, using individual windows looks good.