Two locations on one printout?

[Dave R]

If you have a design that has floors at two different heights and each floor height has a different height ceiling, you are supposed to two locations, correct?  I have this situation.  The two locations are essentially on the level in the house so I want to print out the floor plan with them shown as one level.  How does one do this?

[Allan Chesney]

Hi  Dave,

As a general rule if floor levels and wall heights are different you would have a different location. However you could just Elevate the floor and Ceiling in one part of the room and get the same effect, but you would have to fiddle with Baseboards and Crown Moulding etc too. It would mean you would also have to elevate all the furniture and fittings etc if you wanted them to print (if not you could just have the furniture on the second location set to the higher elevation).

If you currently have them on separate locations now, what you could do is set the Dimming of other locations to zero so all locations will print and then in View Filter, turn off the ones you do not want.

Allan