Probable Floor cover problem

[quintain]

Hi Everyone
TurboFloorPlan Home & Landscape Pro
Windows XP SP2

I am a very new user to TFP and this forum. I have produced a small 2 story test drawing and think I have placed some extra flooring in the drawing which I cannot remove.  I closed the prog down last night after messing about learning how to alter selected room floor covering (the garage had carpet flooring initially). On opening up today I find I have a series of parallel dark blue lines in each room of the ground floor (the lines are disjointed at room walls and then immediately start again in the adjoining room/s). I have tried to put a new floor covering into a room and that has been done but in 2D I still see the lines.
The lines are visible in 2D Plan view and Rendered Outline and Patterns but not visible in 2D Designviews nor in 3D Perspective view.
Can any one assist in this strange happening.
P.S. does the forum rules allow me to send the drawing to the forum and if so how do I do such??
quintain

[quintain]

Hi again every-one
If all else fails think laterally!! before asking a silly question.
I have discovered that I was viewing framing, not flooring, the following post from Jack Zimmer (thank you Jack) was my 'road to Damascus moment'

Jack Zimmer
Displaying FRAMING