Stairs

[aboardduet]

When I try to insert stairs in an automatic floor, I stall when the "hole" I've defined fails to "select", therefore I can't delete it to cut the hole.  Any help??

Thanks

[Jack Zimmer]

Look in Help under 'Openings' / Inserting in  Floors / Automatic and Removing from Floors / Automatic

short answer is to go to 3D view , select Room Division floor area / hit Delete.

Z

[aboardduet]

Thanks Jack.  Worked just like it should.  A note to the effect might be added to the instructions to make it clear that the moves are made in 3D.  The 2D inference is there  when it says: "Go into  3D view and  make sure that the floor is visible in the view".

[Jack Zimmer]

Good to hear it worked , good suggestion for instructions.

Z