Creating Quad & Sheerline Gutters

[Allan Chesney]

Bob,

The Lo-Front guttter is attached.
Did you still want the square one?

Allan

[Burgo]

Allan if it is not too much trouble the square gutter would be great as your production is far better then mine.
Many thanks for the profile gutters you have produced.

[Allan Chesney]

Hi Bob,

I have finally done the box gutter. Attached is a BIM file with the three gutters: Hi-Front, Low-Front and Box and there are repeats of these that are solid - not open. The purpose of these is to use for square ends when required. Just draw a short line, convert to the solid gutter and then you can drag the end in so that it is very short. Obviously you need to Elevate it to the same height as your open gutter and move it into the end of the gutter. Use the Nudge (arrow key) to move it in small increments.

If you are not planning to do overhead views, then you could just use the solid gutter - no one will see the inside and TFP does not have a rain option yet so it won't matter! 

You already have two of the gutters so you just need to Transfer the others from the BIM file.

Allan

[Burgo]

Allan, the gutter profiles you produced are absolutely fantastic, a great job and many thanks.