TFP H&L pro v16 Explore of Tapered Colums

[Kajvin - Robert W]

Hi Allan! If you take a digital photo of real p.v.c then you get structures and colour at same time.  

V16 only
I have look at the Tapered columns the work fine, you  have dx1 and dy1 at bottom and dx2 and dy2 at the top dx2 and dy2 must be less than 1/2 of dx1 and dy1

than example dx1,dy1= 200 mm then the max dx2,dy2 is < 100 mm not = 100mm that give you a square dart point up.
If yo will have a bigger top then bottom the set dx2,dy2 negative number from -0 and -2000 mm, it look like 2000 is max. This can be fun tool to work with. dx1,dy1 are max 5000  dx2,dy2 is max 2000 is width on columns. If dx1=5000 dx2 can be between 0 and 2000, h can be max c.

Try this select tapered Circle Hollow dy1=5000 dy2= 2000 c=2000 h=1999 and t1=4 Have fun
/Robert

[Kajvin - Robert W]

Hi all you can make a nice chimney with Columns and Tapered Columns.

Select Columns
Right click in the catalog and select Element Manager
Select
Select  if you will us a Concrete Columns / Steel Columns or Brick Columns  (You  you fined your Chimney in that folder later)
Open the folder of Columns you have selected
Right click in the left column select Add a element
Go to properties set the parameters for your chimney  Define Column height select User defined
Select Appearance and select what Material you will use
Then your have your custom chimney click on OK and the chimney will save in the catalog
/Robert