electrical/plumbing plans

[omni]

How do I take the basic floor plan and use it for adding electrical outlets, wireing etc?  Similar for laying out the water and sewer lines?  I have been unable to copy the floor plan or move it to make another project.

[Nik]

Hi, I don't have TFP yet, so I'm guessing, and suggesting tricks used in FP...

When you create a new floor-level / location, does TFP ask if you want to 'clone' an existing level, or is default to just start from blank ??

Can you overlay a 'bare' level at same height as room with inch-high, skinny walls for service run, risers made with skinny pillars, junction boxes etc using imported block.3ds ?? With care, you could align these with sinks, oven / hob / range, power-outlets etc...