Stange floor behavior

[Larry276]

I cant figure this one out. One floor in one room is beige no matter what I try to do. If I highlight in in any view, 2D, 3D, etc. it is always identified as a hardwood floor. If I right click and check properties, it is a hardwood floor, but it is beige. I tried elevating it, thinking perhaps I was seeing the top of a ceiling below--didnt help. In the rest of the plan, hardwood floors show as hardwood (rooms on same level as problem floor). What happened?

thanks in advance.

LL

[Allan Chesney]

Is the floor upside down?  I recall a previous comment from someone about a floor that was upside down so you are see the 'underside' instead of the the 'surface'. I have had this happen to me once also, so it was not an isolated incident.  I deleted it and inserted it again and it was fine.  It is also possible to have two or more floors in the one room - the program does not prevent it, but since you have tried elevating it, that is probably not the problem.

If these do not answer the question, then you may have to post the BLD file so the we can try to find the cause.

Allan

[Larry276]

You were right! I changed reverse side to wood floor 3. It worked.